Free shipping on EuroSpeed products over $50

Pay later and financing available at checkout

Choose your car to see parts that fit

CJM Industries Coin Tray 52mm Gauge Pod for Volkswagen Golf MK7 / Golf Alltrack MK7 / Golf Sportwagen MK7 / Golf GTI MK7 / Golf R MK7 (2015–2021)

CJM Industries Coin Tray 52mm Gauge Pod for Volkswagen Golf MK7 / Golf Alltrack MK7 / Golf Sportwagen MK7 / Golf GTI MK7 / Golf R MK7 (2015–2021)

Welcome offer

Unlock 5% off

New parts, install guides and member offers, straight to your inbox.

Customer Reviews

Be the first to write a review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
Free MQB maintenance planner

Know what your car needs, and when

  • Factory schedule plus the interval for a modified car
  • Built for MQB: Golf, GTI, R and S3
  • Log services, track your parts, scan receipts
Open the planner
10k20k30k40k50k60k Engine oil Spark plugs DSG fluid Haldex Brake fluid Air filter
Engine oil and filterDue at 90,000 miin 2,943 mi
Cabin filterDue at 90,000 miin 2,943 mi
Spark plugsDue at 100,000 miin 12,943 mi
DSG fluidDue at 120,000 miin 32,943 mi
Haldex fluidAWD carsin 32,943 mi
Brake fluidEvery 2 yearsin 7 months
Air filterDue at 110,000 miin 22,943 mi
CoolantBy scheduleby condition
DSG serviceGolf R / GTI with the 6-speed DSG (DQ250)
Procedure
1Set selector to P, engine off, car level. Connect the diagnostic tool and read DSG fluid temperature. It must be 35 C or lower before you open anything; if hotter, let it cool.
2Remove the engine top cover. Disconnect the MAF sensor connector and breather hose, loosen the clamp and remove the air duct, undo the air filter box screws and lift the box out to expose the filter housing near the brake master cylinder side of the transmission.
3Place a drain pan under the transmission. Unscrew the filter housing cover, tilt the filter so it drains back into the pan, and remove it with the old sealing ring.
4Lubricate the new sealing ring with fresh DSG fluid. Fit the new filter in the receiving sleeve (wet the ring first) and tighten the cover to 20 Nm. Refit the air filter box, duct, MAF connector and breather hose.
5Raise the car level on supports and remove the underbody protective plate over the transmission if fitted.
6Unscrew the check/level plug beside the rocker support (the transmission's plug at the flange end). Behind it sits a plastic overflow tube.
7Remove the overflow tube with the 8 mm hex key. About 4-5 L drains out. Let it drain fully; measure what came out.
8Refit the overflow tube and tighten to 3 Nm.
9Shake the new fluid bottle. Screw the VAS 6262/2 adapter into the level-check hole by hand and connect the VAS 6262 filling device and bottle. Do not reuse drained fluid.
10Fill 5.5 L of new fluid through the adapter. Close the shut-off valve or hold the bottle above the gearbox when swapping containers.
11Read fluid temperature. Start the engine, hold the brake, and shift through every selector position, holding each about 3 seconds, then return to P. Leave the engine running.
12Watch temperature on the scan tool. When fluid is between 35 and 45 C, disconnect the quick-release coupling at the adapter and let the excess drain out.
13Level is correct once the flow slows to a small drip about every 30 seconds at the hole. Do not top up or compensate for that drip.
14Remove the adapter, fit a new seal to the check plug and tighten to 45 Nm. Stop the engine.
15Refit the underbody cover. Road test and recheck for leaks at the filter cover and check plug.
DSG serviceGolf R / GTI with the 6-speed DSG (DQ250)
Tools
8 mm hex (Allen) key for the plastic overflow tube
VAS 6262 or VAS 6262A DSG filling device with VAS 6262/2 adapter (screws into the level-check hole) and 6262/6 adapter if the bottle thread does not fit
Torque wrench covering 3 Nm to 45 Nm (3 Nm overflow tube, 20 Nm filter cover, 45 Nm check plug)
Filter cover wrench or large socket for the filter housing cover (size not confirmed, see unverified)
Diagnostic tool that reads DSG fluid temperature (VCDS, ODIS or equivalent)
Drain pan of at least 6 L, funnel, nitrile gloves, safety glasses
Screwdriver/pliers for the MAF connector, hose clamps and air filter box screws
Parts
VW DSG fluid G 052 182 A2 (TL 521 82), about 5.5 L per fill
DQ250 filter kit with new sealing ring (VW 02E 305 051 C family; kit commonly lists G052182A2 fluid plus filter)
New check-plug sealing ring (fresh seal each time)
New overflow tube/O-ring if the old one is damaged
Check engine light is onEnter the code your scan tool reads
Diagnose
P0301
Diagnose
P0301
P0301 Cylinder 1 misfire

Usually a failed ignition coil, then a worn plug, then an injector.

Reported fix

Swap the coil with another cylinder. If the misfire follows the coil, replace the coil. If it stays, check the plug, then the injector.

Ignition coilSpark plugs
November2026
SMTWTFS123456789101112131415161718192021222324252627282930
Engine oil and filterNov 12 · due at 90,000 mi
Add to Google Calendar
Apple Calendar (.ics)
Added to your calendar
Your garage
Service log12 services logged
Modifications4 parts, $2,897
Export service record

Service record

2018 Golf R · 62,410 mi · Sample record

Services
MileageServiceNotes
10,120 miEngine oil and filterReceipt kept
20,340 miEngine oil and filter
24,300 miBrake fluidFirst change at 3 years then every 2
30,055 miEngine oil and filter
34,880 miHaldex serviceStrainer cleaned
40,210 miEngine oil and filter
40,210 miDSG serviceFluid and filter
40,210 miSpark plugs
40,210 miCabin air filter
50,480 miEngine oil and filter
60,115 miEngine oil and filter
60,115 miEngine air filter
Modifications
PartPrice paid
APR ECU tune, Stage 2$699
034Motorsport rear sway bar$349
Integrated Engineering intake$399
Coilovers$1,450
Total$2,897

Follow Us on Instagram

img

Added to cart successfully!